Airlink101 LX60 Hardware User's Manual page 24

AirLink LX60 Series Hardware User Guide
Table 2-3: I / O Pin-out Configuration
Location
Auxiliary I/O
Connector /I/O Cable
(SKU # 6001004)
You can use the I/O pins as:
For more information, refer to the ALEOS Software Configuration User Guide.
Note: The I/O pins can be configured in ACEmanager or ALMS to trigger standby mode, to sink
current, or to pull up the voltage. If you are using the I/O line to trigger standby mode, you cannot
configure it to sink current or pull up the voltage. Likewise, if you are using the I/O line to either sink
current or pull up the voltage, you cannot use it to trigger standby mode.
Rev. 2 June 2021
Pin/Wire Digital Analog
Color In
6/Yellow
 
7/Gray
 
2/Orange

3/Purple

1/Black
8/Black
4/ Reserved
5/Reserved
· Pulse counters
(See Table 2-4 on page 25 and
· Digital inputs
(See Table 2-4 on page 25 and
· High side pull-ups/dry contact switch inputs
(See Table 2-6 on page 27 and
· Analog inputs
(See Table 2-7 on page 28 and
· Low side current sinks
(See Table 2-8 on page 29 and
· Digital outputs/open drains
(See Table 2-9 on page 30 and
· RS interface
Note: When RS is enabled, the other functions of I/O pins 2 and 6 (digital and analog inputs 3
and 5) are disabled. The disabled functions include pulse counting, analog input, digital inputs,
and high-side pull-up/dry contact switch.
Digital Pull-up
In Out




Figure 2-11 on page 25.)
Figure 2-12 on page 26.)
Figure 2-13 on page 27.)
Figure 2-14 on page 28.)
Figure 2-16 on page 29.)
Figure 2-17 on page 30.)
24
RS GND DO
NOT
Use






ACEmanager
Configuration
Digital 3
Analog 3
RS > Enable
Digital 2
Analog 2
Digital 5
RS > Enable
Digital 4
41111782