Ethernet Leds - Airlink101 LX60 Hardware User's Manual

AirLink LX60 Series Hardware User Guide
Table 2-10: LED Behavior
LED Color / Pattern
Network Solid Green
Solid Amber
Flashing Green
Flashing Red
Flashing Amber
Flashing Red /
Amber
b
Wi-Fi Off
Solid Green
Solid Amber
Flashing
(Green or Amber)
b
GNSS Solid Green
Flashing Green
Off
ALL Green LED chase
Amber LED chase
Solid Amber
Red LED chase
a. May result from ALMS not reporting the R2C eSIM activation state (the LX60, the eSIM, and ALMS have not synchronized
after device registration or a device reset), or status reports from ALMS have been disabled. Network or server issues may
also result in an unknown activation state.
b. LX60 Wi-Fi + GNSS only

Ethernet LEDs

The connector has two LEDs that indicate speed and activity. When looking into the
connector:
•
•
Rev. 2 June 2021
Connected to an LTE network (using SIM card or R2C eSIM)
Connected to a 3G or 2G network
Connecting to the network
No network available, R2C eSIM not activated
R2C eSIM activation state unknown
Network Operator Switching is enabled, but the router is unable to locate the
required firmware. For more information, refer to the ALEOS Software
Configuration User Guide (Admin chapter).
Wi-Fi is disabled. (Configurable in ACEmanager and ALMS)
Wi-Fi is enabled.
Wi-Fi is enabled, and the router is connected to an Access Point.
(i.e. Wi-Fi is being used as the WAN connection)
Wi-Fi traffic is being sent or received.
The router has a GNSS fix.
No GNSS fix
GNSS is disabled. (Configurable in ACEmanager and ALMS)
Radio module reconfiguration/firmware update or Network Operator Switching is
in progress.
ALEOS software update is in progress.
ALEOS software update complete
Recovery mode
Activity—The right LED indicates the link status:
· Solid—Link
· Blinking Amber—Activity
· Off—No link
Connection Speed—The left LED indicates the Ethernet connection speed:
· Solid Green—1000 Mbps (Gigabit)
· Off—10/100 Mbps
Description
a
32 41111782