Daikin Sky Air Advance RZA200D7Y1B Service Manual page 127

To install the solenoid valve coil
RZA200+250D7Y1B
Sky Air Advance-series
ESIE19-13A – 2020.05
CAUTION
Overheating the valve will damage or destroy it.
4 After soldering is done, stop the nitrogen supply after the component has
cooled‑down.
5 To install the solenoid valve coil, see
6 Add refrigerant
4
procedures" [ 142].
1 Install the solenoid valve coil on the solenoid valve body.
a Screw
b Solenoid valve coil
c Bracket
d Screw
e Solenoid valve body
2 Install and tighten the screw to fix the solenoid valve coil to the solenoid valve
body.
3 Install and tighten the screws to fix the solenoid valve to the bracket.
4 Route the solenoid valve harness towards the switch box.
5 Connect the solenoid valve connector to the main PCB.
WARNING
When reconnecting a connector to the PCB, do NOT apply force, as this may damage
the connector or connector pins of the PCB.
6 Fix the solenoid valve harness using new tie straps.
INFORMATION
Replace all cable ties that were cut during removal.
Is the problem solved?
Yes
"3.14.2 Repair
to the refrigerant
c a d b
e
Action
No further actions required.
3 Components
|
4
procedures" [ 124].
circuit, see "4.2.2 Repair
Service manual
127