Usage Of Asr - Fujitsu PRIMERGY LTO4 User Manual

B.2

Usage of ASR

This section explains the procedure for ASR usage.
Prearrangement
When a nonstandard Windows driver (RAID driver, SAS driver, etc.) is necessary, prepare the
following before executing ASR.
1
Create a floppy disk of a nonstandard Windows driver.
For creation procedures, refer to the server's "User's Guide" or the SAS card's "User Guide".
2
Create a driver floppy disk for an occasion when asked for a driver
file in the middle of restoring ASR.
1. Check whether the free space in the driver floppy disk created in Step 1 is
2. Create a folder [\$OEM$\TEXTMODE] in respective floppy disk.
3
Copy all the files placed lower in the root than the driver floppy
disk created in Step1 to the folder created in Step 2.
For notes on FDD Unit (USB) usage, refer to "3.7 For Using FDD (USB) when
Operating ASR" ( p.74).
How to use ASR
1
Turn on the server.
2
Insert the ASR floppy disk and Windows Server 2003 installation
CD.
System starts up from the Windows Server 2003 installation CD.
A message "Press F2 to run Automated System Recovery (ASR) ..." appears on the bottom of
the screen. Note that this message appears only for about five seconds.
98
720KB or more.
If the free space is not sufficient, prepare an extra floppy disk.
When a nonstandard Windows driver (RAID driver, etc.) is necessary, the
message "Press F6 if you need install a third party SCSI or RAID driver ..." is
shown on the bottom of the screen. In this case, press [F6] key. Note that this
message appears only for about five seconds.