Fujitsu PRIMERGY LTO4 User Manual page 86

LED Display
Two-color: Blinking (amber)
Segment: C
One-color: On
Two-color: Blinking (amber)
Segment: 1
One-color: Off
Two-color: Blinking (amber)
Segment: 2
One-color: Off
Two-color: Blinking (amber)
Segment: 3
One-color: Off
Two-color: Blinking (amber)
Segment: 4
One-color: Off
Two-color: Blinking (amber)
Segment: 5
One-color: Off
Two-color: Blinking (amber)
Segment: 6
One-color: Off
Two-color: Blinking (amber)
Segment: 7
One-color: Off
86
Status and Action
Status Cleaning request: Needs cleaning.
Action Clean this product with a cleaning cartridge.
"5 Cleaning"(p.81)
If the status does not change after cleaning, the
media may be worn out.
Status Temperature abnormality is detected: The
temperature value is abnormal.
An abnormality is detected when the temperature in
the tape drive is higher than 55°C.
Action Lower the temperature around the server below
35°C. If the status does not change after setting the
temperature below 35 °C when the tape is not being
accessed, a failure may occur.
Status Voltage abnormality is detected: The voltage value
is abnormal. Servo control becomes impossible
when the 12V line gets lower than 9V.
Action Shut down the server to reboot it. If the status does
not change, a failure may occur.
Status The firmware update failed.
Action Shut down the server to reboot it, and update the
firmware again. If the status does not change, a
failure may occur.
Status A drive hardware error was detected.
Action Shut down the server to reboot it. If the status does
not change, a failure may occur.
Status A hardware abnormality was detected.
Action (1) Turn the server on and off.
(2) If the problem still remains, replace this product
(LTOUnit).
(3) If the problem still remains even though the
above actions are taken, replace the DC cable or
power unit of the server.
Status The data cartridge is abnormal.
Action Replace the data cartridge. If the status does not
change, a failure may occur.
Status Incompatible cartridge inserted: A data cartridge
whose format was incompatible (LTO1) was
inserted.
Action Press the Eject button to eject the data cartridge and
insert a correct data cartridge.
"4.1 Usable Data Cartridges"(p.75)