Device Driver Installation (For Primergy Ft) - Fujitsu PRIMERGY LTO4 User Manual

11
Click [Finish].
12
Click [Close].
"Quantum LTO 4 Tape Drive" is displayed under "Tape Drive".
13
Restart the server.
3.3.2

Device Driver Installation (For PRIMERGY FT)

Notes
• This product can be installed only to FT1. It cannot be installed to FT2.
• Two of this product cannot be installed at the same time.
• This product can only be used from a Virtual Server (professional-use OS). This product cannot be
used from a CoServer (input-output OS).
• FT model cannot restore the system using Automated System Recovery (ASR) set or system
recovery disk. For restoration, use the recovery CD supplied with the server.
• For installation of the internal 5-inch option, refer to the "User's Guide" of the FT model.
For Windows Server 2003 (Windows Server 2003 x64 is not included)
1
Install this product in FT1.
2
Turn on the power of FT1 and FT2, and start the CoServer in online
mode.
3
Log on to the CoServer1 with administrator privileges.
4
Click the [Start] button – [Control Panel] – [System].
5
Select the [Hardware] tab and click [Device Manager].
The device manager starts.
6
Double-click [Tape Drive], and then double-click [Quantum LTO 4
Tape Drive].
7
Select the [Driver] tab and click [Update Driver].
The Setup Wizard appears.
8
When the "Can Windows connect to Windows Update to search for
software?" message appears, click [No, not this time] and then
click [Next >].
Follow the wizard for installation.
9
For installation methods, select [Install from a list or a specific
location] and click [Next >].
70