Fujitsu PRIMERGY LTO4 User Manual page 64

LED display specification list
The LED combinations are as follows. For LED details, refer to "7 Troubleshooting" ( p.85).
Two-color
LED
Off
On (green)
On (green)
Blinking
(green)
Blinking
(green)
On (green)
Blinking
(amber)
Blinking
(amber)
Blinking
(amber)
Blinking
(amber)
Blinking
(amber)
Blinking
(amber)
Blinking
(amber)
Blinking
(amber)
Blinking
(amber)
Blinking
(amber)
Blinking
(amber)
Blinking
(amber)
Blinking
(amber)
Blinking
(amber)
Off
*: The LED is not turned off until cleaning has normally completed (even if the server's power is
turned off, the LED is not turned off).
64
Segment One-color
LED LED
Off Off PowerOff: Power is not supplied to this product.
PowerOn (No cartridge): Power is supplied and a data cartridge can
– Off
be inserted manually.
Ready: Power is supplied and a data cartridge is recognized by the
Off Off sensor. When the data cartridge has been loaded, this product can be
used.
Running: This product is loading/unloading, unwinding the data car-
Off Off
tridge, or writing/reading data on the data cartridge.
C Blinking Cleaning
A write-protected cartridge or LTO2 (Read Only) cartridge was
P Off
loaded.
F Blinking Updating the firmware.
C On Cleaning request (*): Needs cleaning.
1 Off The temperature value is abnormal.
2 Off The voltage value is abnormal.
3 Off The firmware update failed.
4 Off A drive hardware error was detected.
5 Off A hardware abnormality was detected.
6 Off The data cartridge is abnormal.
Incompatible cartridge inserted:
7 Off
A data cartridge whose format was incompatible (LTO1) was inserted.
8 Off Interface error
A Off The data on the data cartridge memory is abnormal.
c
(lower- Off An unusable cleaning cartridge was inserted.
case)
L Off An error occurred when the data cartridge was loaded.
U Off An error occurred when the data cartridge was unloaded.
L On The Eject button was pressed while application software was running.
Status