Installing The Control Panel - Dell PowerEdge R430 Owner's Manual

Figure 90. Removing the control panel—ten 2.5-inch hard drives/SSDs chassis
1. screw
3. cable securing clip
5. J_FP_USB connector cable
Next steps
1. Replace the control panel.
2. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 71
Related tasks
Before working inside your system

Installing the control panel

After working inside your system
Installing the control panel
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
154 Installing and removing system components
on page 72
on page 154
on page 72
2. control panel release latch
4. control panel cable connecting to the system board
6. control panel