Dell PowerEdge R430 Owner's Manual page 149

Figure 84. Cabling diagram—Ten 2.5 inch SAS/SATA backplane
1. SW_RAID_A connector on the system board
3. SATA_hard drive8 connector on the system board
5. cable routing latch
7. SAS_B connector on the backplane
9. hard drive/SSD backplane
Next steps
1. Install the hard drive backplane.
2. Install all the hard drives into their original slots.
3. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 71
Related tasks
Before working inside your system
Removing a hot swappable hard drive carrier
Installing the hard drive backplane
Installing a hot swappable hard drive carrier
After working inside your system
on page 72
on page 95
on page 150
on page 96
on page 72
2. SW_RAID_B connector on the system board
4. SATA_hard drive9 connector on the system board
6. SAS_A connector on the backplane
8. SAS_C connector on the backplane
10. system board
Installing and removing system components 149