Dell PowerEdge R420 Installation Manual
Second processor installation–information update
Hide thumbs
Also See for PowerEdge R420:
- Owner's manual (145 pages) ,
- Technical manual (51 pages) ,
- Getting started manual (9 pages)
Related Manuals for Dell PowerEdge R420
Summary of Contents for Dell PowerEdge R420
- Page 1 Dell PowerEdge R520 And PowerEdge R420 Systems Second Processor Installation–Information Update...
-
Page 2: Notes, Cautions, And Warnings
Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden. Trademarks used in this text: Dell™, the DELL logo, and PowerEdge™, are trademarks of Dell Inc. Other trademarks and trade names may be used in this publication to refer to either the entities claiming the marks and names or their products. - Page 3 Expansion-Card Risers" and "Technical Specifications" in the Owner’s Manual at support.dell.com. NOTE: When selecting or upgrading your system configuration, verify the system power consumption with the Dell Energy Smart Solution Advisor at dell.com/ESSA to ensure optimum power utilization. Additonal Processor Installation...
-
Page 4: Removing A Processor Blank
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. - Page 5 Figure 1-1. Removing and Installing a Processor Blank/Processor processor blank/processor processor shield notches in processor (2) socket keys (2) ZIF socket socket-release lever Additonal Processor Installation...
-
Page 6: Installing The Second Processor
Installing the Second Processor CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. Before you begin this procedure, review the safety instructions that came with the system. 1 Ensure that you have followed the steps mentioned in "Before You Begin" on page 3. - Page 7 Figure 1-2. Installing the Heat Sink retention sockets (4) heat sink retention screws (4) 9 Install the cooling shroud. For more information, see "Installing the Cooling Shroud" in the Owner’s Manual. 10 Close the system. Additonal Processor Installation...
- Page 8 11 Reconnect your system and peripherals to their electrical outlets, and turn on the system. 12 Press <F2> to enter the System Setup and check that the processor information matches the new system configuration. 13 Run the system diagnostics to verify that the new processor operates correctly.