Disabling Forgotten Password - Dell PowerEdge R430 Owner's Manual

Table 45. System board jumpers and connectors
Item Connector
16 NIC4
17 NIC3
18 B1, B2
19 USB2_3.0
20 USB1
21 NIC1 and NIC2
22 B3, B4
23 CPU2
24 PWR_CONN_C(P3)
25 CPU1
26 IDSDM
27 INTRUSION
28 FAN6
29 A1, A5, A2, A6
30 FAN5
31 FAN4
32 PWR_CONN_B(P2)
33 A3, A7, A4, A8
34 FAN3
35 FAN2
36 BP_SIG
37 ODD_PWR
Related references
System board jumper settings
Expansion card installation guidelines

Disabling forgotten password

The software security features of the system include a system password and a setup password. The password jumper enables or
disables password features and clears any password(s) currently in use.
Steps
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2. Remove the system cover.
172 Jumpers and connectors
on page 170
on page 112
Description
The PCIE_G3_X8 and PCIE_G3_X16 are
NOTE:
the two different types of risers supported on
R430 systems. You can install an expansion card
on the system board only using expansion card
riser. For more information about the installation
guidelines, see the Expansion card installation
guidelines section.
Network connector
Network connector
Memory module socket
USB connector
USB connector
Network connector
Memory module socket
Processor socket 2
8-pin power connector
Processor socket 1
Internal Dual SD Module connector
Intrusion switch connector
Cooling fan connector
Memory module socket
Cooling fan connector
Cooling fan connector
8-pin power connector
Memory module socket
Cooling fan connector
Cooling fan connector
Backplane signal connector
Optical disc drive connector