Fujitsu PRIMEQUEST 500A Series Installation Manual page 132

CHAPTER 3 Operating System Installation
3.2.1.4 Installing the Linux OS
Boot the OS from the CD to install it.
For details, see the PRIMEQUEST Installation Support Tool User's Guide (Red Hat)
(C122-E005EN) or the PRIMEQUEST Installation Support Tool User's Guide
(SUSE) (C122-E047EN).
Follow the instructions from the installer displayed on the KVM display to change the
CD-ROM. After Linux OS installation is complete, the system is rebooted.
Note:
3.2.1.5 Installing attached software programs
After installing the OS, follow the instructions displayed on the KVM display to
insert the supplied CD-ROM into the KVM DVD-ROM drive and install the attached
software program. For details of the bundled-software package installer, see the
PRIMEQUEST Installation Support Tool User's Guide (Red Hat) (C122-E005EN) or
the PRIMEQUEST Installation Support Tool User's Guide (SUSE) (C122-E047EN).
3.2.1.6 Work required after installation
After installation is complete, remove the USB floppy drive from the USB port of the
KVM interface unit. Then, set the PCI address mode.
Set "PCI Segment Mode" as the PCI address mode of the partition in which the
operating system has been installed. For information on the setting method, see
Section 2.5.8, "Setting various modes."
After setting the PCI address mode, perform the installation work for the Linux OS.
For further information, see
Installation."
3-10
Switching the partition connected to the KVM devices during Linux OS
installation may stop Linux OS installation and cause an I/O error. Do not
perform KVM switching during installation.
Chapter 4, "Work Required After Operating System
C122-E001-10EN