Fujitsu PRIMEQUEST 500A Series Installation Manual page 333

When a tape unit connected to the remote host is used
1
Start the network.
# /etc/rc.d/init.d/network start
2
Activate the network.
# ifconfig eth0 xxx.xxx.xxx.xxx netmask xxx.xxx.xxx.xxx
broadcast\
xxx.xxx.xxx.xxx
Remarks: Set values such as the IP address according to your system.
3 Prepare a tape unit.
Use the mt command with the ssh command for operation with a remote tape
unit.
For details, see the mt command manual.
• Rewind tape.
# ssh remote-host-name mt -f /dev/nst0 rewind
Enter the password in response to the password prompt.
4
Back up.
Use the ssh command for the backup operation.
• For a file system other than /boot/efi
Back up with the dump command.
# dump 0f - /dev/sda2 | ssh remote-host-name dd of=/dev/nst0
Enter the password in response to the password prompt.
• For /boot/efi
Back up with the tar command.
# cd /boot/efi
# tar czvf - . | ssh remote-host-name dd of=/dev/nst0
Enter the password in response to the password prompt.
C122-E001-10EN
\: Indicates that no line feeds should be inserted.
4.12 OS Backup Settings
4-147