Fujitsu PRIMEQUEST 500A Series Installation Manual page 408

Appendix D Installation in the SAN Boot Environment
5 Select the HBA.
From the displayed HBA list, select the one to be used for SAN boot by moving
the cursor to it, and press the [Enter] key. The HBA setup utility menu is
displayed.
------------------------------------------------------------------------
001: LP11002
------------------------------------------------------------------------
6 Display of setup menu for HBA setup utility
Select [1. Setup Utility], then press the [Enter] key. The following menu is
displayed.
----------------------------------------------------------------------
001: LP11002
01
----------------------------------------------------------------------
7
Obtaining the HBA WWPN
Displaying the setup menu for HBA setup utility in step 6 above displays the
HBA WWPN for "Port Name."
8
Initialize the HBA settings.
Select [4. Reset to Default Values] from the menu displayed in step 6.
Enter "y" in the displayed dialog box to initialize the HBA settings.
Do you want to Force defaults (y/n) :
Note:
D-14
Emulex FC EFI-Bios Utility, Ver: 3.11a4
PCI-X 133MHz
HBA Status: Ready
EFI Boot : BE3.11A4
1. Setup Utility
2. Firmware Update
Emulex FC EFI-Bios Setup Utility, Ver: 3.11a4
PCI-X 133MHz
Boot Bios : Disabled
Port Name : 10000000C9537FB3
S_ID : 000000
1. Enable or Disable BIOS
2. Configure HBA Parameters
3. Configure Boot Parameters
4. Reset to Default Values
This operation is not required in the system state immediately
following shipment from the factory.
Seg#: 00 Bus#: 49 Dev#: 01 Func#: 01
Boot Bios : Disabled
Firmware
Seg#: 00 Bus#: 49 Dev#: 01 Func#:
Firmware : BS2.10A7
Node Name : 20000000C9537FB3
Link Speed: NA
: BS2.10A7
I/O Base : 8200
Topology : Invalid
C122-E001-10EN