Fujitsu PRIMEQUEST 500A Series Installation Manual page 401

D.4.4 Configuring the EFI driver
To boot from a SAN storage unit, follow the procedure below for each HBA.
The EFI driver that is used varies depending on the mounted FC card. The displayed
content is different for the different versions of the driver. This section describes a
procedure appropriate to each version.
Configuring the EFI driver (3.10a6 version)
Configuring the EFI driver (3.11a4 version/3.11x1 version)
D.4.4.1 Configuring the EFI driver (3.10a6 version)
1
Turn on power to the partition.
The [EFI Boot Manager] window is displayed on the console.
EFI Boot Manager ver x.xx [x.xx]
Please select a boot option
EFI Shell [Built-in]
DVD/Acpi(PNP0A03, 0)/Pci(1D|1)/Usb(0, 0)/Usb(1, 0)
Network/Acpi(PNP0A03,0)/Pci(1E|0)/Pci(8|0)/Mac(000B5D6F80A9)
Boot Option Maintenance Menu
Setup Menu
2 Start EFI Shell.
Select [EFI Shell (Built-in)], and press the [Enter] key.
EFI Shell starts.
3
List drivers.
After EFI Shell starts, enter the following, and press the [Enter] key:
Shell> drivers -b
A list of drivers is displayed as shown below.
Find the line with "Emulex SCSI Pass Thru Driver" displayed in the DRIVER
NAME column, and record its value in the DRV column. In the following
example, 22 is the driver identification number.
C122-E001-10EN
→
( D.4.4.1)
→
( D.4.4.2)
D.4 Settings
D-7