Fujitsu PRIMEQUEST 500A Series Installation Manual page 115

Mirror Mode
(Current status)
Mirror Mode
(setting)
Hyper Threading
(current)
(available only in the
PRIMEQUEST 500A/
500 series)
Hyper Threading
(setting)
(available only in the
PRIMEQUEST 500A/
500 series)
Dynamic Partitioning
(current)
(PRIMEQUEST 580A/
540A series only)
Dynamic Partitioning
(setting)
(PRIMEQUEST 580A/
540A series only)
C122-E001-10EN
Item
Displays the modes that are currently valid.
Sets a Mirror Mode by selecting one of the following modes.
For details on the Mirror Mode, see the System Design Guide.
• Standard Mirror Mode
• Extended Mirror Mode
Note: When [Mirror Mode] is set as [Disable] in the [System
Setup] window, [Mirror Mode] is grayed out and cannot
be selected.
The default is [Standard Mirror Mode].
Indicates whether the Hyper Threading function is enabled or
disabled.
• Enabled: Hyper Threading is enabled.
• Disabled: Hyper Threading is disabled.
Enables or disables the Hyper Threading function.
• Enable: Enables Hyper Threading.
• Disable: Disables Hyper Threading.
The default for Hyper Threading is [Disable] (disabled).
Displays whether the Dynamic Partitioning function is enabled.
• Enabled: Dynamic Partitioning is enabled.
• Disabled: Dynamic Partitioning is disabled.
Specifies whether to enable the Dynamic Partitioning function.
• Enable: Enables Dynamic Partitioning.
• Disable: Disables Dynamic Partitioning.
Note:
The DP function is not supported in any of the cases listed
below. In these cases, set [Disable] since operation cannot be
guaranteed; setting [Enable] leads to a possibility that
installation cannot be performed correctly.
• The system used runs under RHEL with a version level
earlier than RHEL 5.1 (IPF).
• The system used runs a Windows version earlier than
Windows Server 2008.
• The system used runs under SUSE.
• The virtual machine function is used.
The default setting is [Disable] (disabling Dynamic
Partitioning).
For details, see the PRIMEQUEST 580A/540A Dynamic
Partitioning (DP) Manual (C122-E085EN).
2.5 Partition Initialization
Description
2-69