Samson TROVIS 3730-3 Mounting And Operating Instructions page 174

Annex A (configuration instructions)
Menu
Angle limitation
Timeout
Zero calibration
error
Zero calibration
timeout
Zero calibration:
shift >>
Configuration
Combination of
options invalid
Forced venting
switch incorrect
Binary input option
A active
Binary input option
B active
External position
sensor error
16-16
10.1.1.21
Recommended action: Check positioner attachment, lever and pin position.
10.1.1.22
10.1.1.23
Recommended action: Check positioner mounting, pin position and supply air.
10.1.1.24
10.1.1.25
Recommended action: Check positioner attachment, pin position and supply
10.1.1.26
Recommended action: Check positioner attachment, pin position and supply
10.1.1.27
10.1.1.28
Recommended action: Check positioner attachment, pin position and supply
10.1.1.29
10.1.1.30
Recommended action: Contact our after-sales service.
10.1.1.31
Recommended action: Contact our after-sales service.
10.1.1.32
10.1.1.33
10.1.1.34
Recommended action: Check sensor and sensor lead.
Adjustment range/values [default setting]/description
The maximum permissible angle of rotation (±30°) has
been exceeded.
Confirm to clear message.
Initialization took too long.
Possible cause: valve blockage.
Check piping and configuration of the mounting parts.
Confirm to clear message.
The zero calibration could not be completed. The forced
venting may possibly be active.
air. Check the set operating mode. Search for the
reason why the forced venting was triggered.
Zero calibration took too long.
air.
Confirm to clear message.
The difference to the previous zero point is too large.
air.
Status indicators
Impermissible combination of options
Impermissible mounting situation for forced venting
option
Reading matches the configuration of optional
additional function.
Reading matches the configuration of optional
additional function.
The sensor or sensor lead are defective.
EB 8484-3 EN