Samson TROVIS 3730-3 Mounting And Operating Instructions page 106

Start-up and configuration
WARNING
!
Risk of injury by exposed moving parts on the positioner, actuator or valve.
Î Do not touch or block exposed moving parts.
NOTICE
!
The process is disturbed by the movement of the actuator or valve.
Î Do not perform the initialization while the process is running. First isolate the plant by
closing the shut-off valves.
Note
The initialization can only be started over the menu after configuration has been enabled.
(within Start-up [7] menu) until Start initialization [7.21] appears.
1. Turn
2. Press to start initialization.
3. Confirm warning with OK.
4. Wait until the initialization process is completed.
After initialization, the positioner remains in the Start initialization [7.21] menu item.
pressed down for two seconds to return to the main menu.
Î Keep
Î Keep pressed down again for two seconds to return to the start screen.
Î The positioner is ready for use.
Tip
Initialization can also be started by pressing the initialization key (INIT). See the 'Operation'
section.
7-10 EB 8484-3 EN