HP 8163A Series Programming Manual page 106

Measurement Operations & Settings
command:
syntax:
description:
parameters:
response:
example:
affects:
command:
syntax:
description:
parameters:
response:
example:
affects:
command:
syntax:
description:
parameters:
response:
example:
affects:
command:
syntax:
description:
parameters:
N O T E
response:
example:
affects:
106
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:STARt?
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:STARt?
Returns the starting point of the sweep.
none
The wavelength at which the sweep starts as a float value in meters.
→
wav:swe:star? +1.50000000E-006<END>
All tunable laser modules
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:STOP
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:STOP<wsp><stop value>
[PM|NM|UM|MM|M]
Sets the end point of the sweep.
The wavelength at which the sweep ends as a float value in meters.
If you specify no units in your command, meters are used as the default.
none
wav:swe:stop 1550nm
All tunable laser modules
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:STOP?
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:STOP?
Returns the end point of the sweep.
none
The wavelength at which the sweep ends as a float value in meters.
→
wav:swe:stop? +1.55000000E-006<END>
All tunable laser modules
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:[STATe]
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:[STATe]<wsp>
STOP|0|STARt|1|PAUSe|2|CONTinue|3
Stops, starts, pauses or continues a wavelength sweep.
0 or STOP: Stop the sweep.
1 or STARt: Start a sweep, run sweep.
2 or PAUSe: Pause the sweep.
3 or CONTinue: Continue a sweep.
When you enable lambda logging, see
"[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:LLOGging" on page 103, and
modulation, see "[:SOURce[n]][:CHANnel[m]]:AM:STATe[l]" on page 90,
simultaneously, a sweep can not be started.
none
wav:swe STOP
All tunable laser modules
HP 8163A Lightwave Multimeter, HP 8164A Lightwave Measurement System,
& HP 8166A Lightwave Multichannel System User's Guide, E1299
Signal Generation – The SOURce Subsystem