Table of Contents
Advertisement
Measurement Operations & Settings
command:
syntax:
description:
parameters:
response:
example:
affects:
command:
syntax:
description:
parameters:
response:
example:
affects:
command:
syntax:
description:
parameters:
response:
example:
affects:
104
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:MODE?
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:MODE?
Returns the sweep mode.
none
STEP:
Stepped sweep mode
MAN:
Manual sweep mode
CONT:
Continuous sweep mode
→
wav:swe:mode?
STEP<END>
All tunable laser modules
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:PMAX?
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:PMAX?<wsp><start wavelength>,
<stop wavelength>
Returns the power to the highest permissible power for the selected wavelength sweep.
start wavelength:
The wavelength at which the sweep starts as a float value.
stop wavelength:
The wavelength at which the sweep starts as a float value.
The highest permissible power for the selected wavelength sweep as a float value.
wav:swe:pmax? 1540,1550 → +3.5500000E-004<END>
All tunable laser modules
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:REPeat
[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:REPeat<wsp><mode>
Sets the repeat mode.
ONEWay:
every sweep cycle starts at the start wavelength of the sweep and ends at the
stop wavelength of the sweep
TWO-
odd sweep cycles start at the start wavelength of the sweep and even sweep
Way:
cycles start at the stop wavelength of the sweep
Set the start and stop wavelength of the sweep using
"[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:STARt" on page 105
and "[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:STOP" on
page 106 respectively.
none
wav:swe:rep twow
All tunable laser modules
HP 8163A Lightwave Multimeter, HP 8164A Lightwave Measurement System,
& HP 8166A Lightwave Multichannel System User's Guide, E1299
Signal Generation – The SOURce Subsystem
Advertisement
Table of Contents
