Table of Contents
Advertisement
Sampling (SAMPLING)
Resampling a Sample (RESAMPLE)
Resampling means sampling a sample itself while itʼs playing back. You can sample the sound of a sample to which
effects are applied, or sample the sound of multiple samples that are playing back at the same time, creating a single
sample.
Also, by turning the pattern sequencer on beforehand (the [PATTERN SELECT] button lights up), you can resample a
pattern in the same way as you would resample a sample.
1
Press the [RESAMPLE] button.
The metronome sounds when the "Metronome:REC" parameter is "ON" (the SYSTEM parameter "CLICK").
Press pad [9] while holding down the [SHIFT] button to turn the metronome sound on/off.
2
Press the [RECORD SETTING] button.
The input setting screen appears.
3
Use the [CTRL 2] knob to set ROUTING to "Mix."
When ROUTING is set to "ExtIn," only the audio input from an external device is sampled (the sampleʼs
audio is not included in the resample). You can sample your performance while playing back samples as
backing sounds.
4
Use the [CTRL 1] knob to adjust the tempo during sampling (the sample tempo), and use the [CTRL
3] knob to adjust the volume of audio input from an external device.
5
Press the [EXIT] button or the [RESAMPLE] button.
6
Press pads [1]‒[16] that are blinking red.
The empty pads to which samples havenʼt been assigned blink red.
When you press an empty pad, the pad lights up orange, and a message "Press Pad to START" is shown.
Advertisement
Table of Contents
