Maintenance Setup - ZyXEL Communications NBG7815 User Manual

Table 52 Settings > System > Remote Access (continued)
LABEL
Wake on LAN
Wake on LAN Status
Port
Wake on LAN MAC Address
Start
APPLY
CANCEL

13.6 Maintenance Setup

Use this screen to upgrade firmware, restart or reset your NBG7815.
Online Firmware
Find firmware at
extension, for example, "V1.00(ABCS.0)C0.bin". The upload process uses HTTP (Hypertext Transfer
Protocol) and may take up to 2 minutes. After a successful upload, the system will reboot.
System Restart
System restart allows you to reboot the NBG7815 without turning the power off.
Reset to Factory Default
Click the RESET TO FACTORY DEFAULT button in this section to clear all user-entered configuration
information and returns the NBG7815 to its factory defaults.
You can also press the Reset button on the rear panel to reset the factory defaults of your NBG7815.
Click Settings > System > Maintenance to show the following screen.
Chapter 13 System
DESCRIPTION
Select Enable to have the NBG7815 forward a WoL "Magic Packet" to all devices on
the LAN if the packet comes from the WAN or remote network and uses the port
number specified in the Port field. A LAN device whose hardware supports Wake on
LAN then will be powered on if it is turned off previously.
Enter a port number from which a WoL packet is forwarded to the LAN.
This field displays the hostname and MAC address of the LAN device by default.
Otherwise, select User-Defined to enter the MAC Address of the device on the
network that will be turned on.
A MAC address consists of six hexadecimal character pairs.
Click this to have the NBG7815 generate a WoL packet and forward it to turn the
specified device on.
A screen pops up displaying MAC address error if you input the MAC address
incorrectly.
Click APPLY to save your changes back to the NBG7815.
Click CANCEL to begin configuring this screen afresh.
www.zyxel.com in a file that uses the version number and project code with a "*.bin"
NBG7815 User's Guide
141