Table of Contents
Advertisement
Figure 81 Settings > System > Remote Access (Bridge Mode)
The following table describes the labels in this screen.
Table 48 Settings > System > Remote Access
LABEL
HTTPS
Server Port
Access Interface
Remote Assistance
Enable Remote Assistant
Wake on LAN
Wake on LAN Status
Port
Wake on LAN MAC Address
Start
Apply
Cancel
13.6 Maintenance Screen
Use this screen to upgrade firmware, restart or reset your NBG7815.
Chapter 13 System
DESCRIPTION
You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Select the interface(s) through which a computer may access the NBG7815 using
this service.
Select Enable to allow customer support to help you solve the problems you
encounter with your NBG7815 remotely.
Select Enable to have the NBG7815 forward a WoL "Magic Packet" to all devices on
the LAN if the packet comes from the WAN or remote network and uses the port
number specified in the Port field. A LAN device whose hardware supports Wake on
LAN then will be powered on if it is turned off previously.
Type a port number from which a WoL packet is forwarded to the LAN.
This field displays the hostname and MAC address of the LAN device by default.
Otherwise, select User-Defined to enter the MAC Address of the device on the
network that will be turned on.
A MAC address consists of six hexadecimal character pairs.
Click this to have the NBG7815 generate a WoL packet and forward it to turn the
specified device on.
A screen pops up displaying MAC address error if you input the MAC address
incorrectly.
Click Apply to save your changes back to the NBG7815.
Click Cancel to begin configuring this screen afresh.
NBG7815 User's Guide
139
Advertisement
Table of Contents
