Table of Contents
Advertisement
Settings > System > Remote Access (Bridge Mode)
Fig ure 82
The following table describes the labels in this screen.
Table 48 Settings > System > Remote Access
L ABEL
HTTPS
Server Port
Access Interface
Remote Assistance
Enable Remote Assistant
Wake on LAN
Wake on LAN Status
Port
Wake on LAN MAC Address
Start
Apply
Cancel
13.6 Ma inte na nc e Sc re e n
Use this screen to upgrade firmware, restart or reset your NBG6818.
Chapter 13 System
DESC RIPT IO N
You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Select the interface(s) through which a computer may access the NBG6818 using
this service.
Select
to allow customer support to help you solve the problems you
Ena b le
encounter with your NBG6818 remotely.
Select
to have the NBG6818 forward a WoL "Magic Packet" to all devices on
Ena b le
the LAN if the packet comes from the WAN or remote network and uses the port
number specified in the
Po rt
LAN then will be powered on if it is turned off previously.
Type a port number from which a WoL packet is forwarded to the LAN.
This field displays the hostname and MAC address of the LAN device by default.
Otherwise, select
Use r- De fine d
network that will be turned on.
A MAC address consists of six hexadecimal character pairs.
Click this to have the NBG6818 generate a WoL packet and forward it to turn the
specified device on.
A screen pops up displaying MAC address error if you input the MAC address
incorrectly.
Click
to save your changes back to the NBG6818.
Apply
Click
to begin configuring this screen afresh.
C a nc e l
NBG6818 User's Guide
136
field. A LAN device whose hardware supports Wake on
to enter the MAC Address of the device on the
Advertisement
Table of Contents
