Ricoh Aficio MP1812L Operating Instructions Manual page 50

Troubleshooting When Using the Printer Function
Problem
Printing does not start. If the machine is operating in an
Printing does not start. The extended wireless LAN has
Printing does not start. Advanced encryption has been set
4
Printing does not start. The login user name, password, or
Data In indicator does
not blink or light up.
The status indicator of
the machine is red.
Updating destination
list. Reselect destina-
tion(s) or sender's
name later.
[List/Test Print] is disa-
bled.
Printing does not start
when using extended
wireless LAN in Ad-
hoc mode.
If the printing does not start, contact your service representative.
44
Cause
extended wireless LAN, the re-
ceiver's MAC address may be
preventing communication with
the access point.
not started.
using the Extended Security function.
driver encryption key is invalid.
If the Data In indicator is unlit or
not flashing even after perform-
ing [Print], the machine has not re-
ceived the data.
The cause is displayed on the dis-
play of the control panel.
The destination list is being up-
dated from the network using
SmartDeviceMonitor for Admin
or Web Image Monitor.
A mechanical error might have
occurred.
Correct communication mode is
not set.
Solution
Check access point settings when
in infrastructure mode. Depending
on the access point, client access
may be limited by MAC address.
Also, check there are no problems in
transmission between access point
and wired clients, and between ac-
cess point and wireless clients.
Confirm the orange LED is lit,
and the green LED is lit or blinks
during transmission.
Check the settings of the Extended Se-
curity function with the administrator.
Check the login user name, password,
or driver encryption key is correct.
• When the machine is connect-
ed to a computer via a cable,
check the computer print port
settings are correct. For how
to check the print port, see
"Confirming the Connection
Method", Printer Reference.
• When it is networked with a com-
puter, contact the administrator.
Check the error message on the
display panel and take required
action. See p.39 "When a Message
Appears".
Wait until the message disap-
pears. Do not switch off the pow-
er while this message is
displayed. Depending on the
number of destinations to be up-
dated, there may be some delay
before you can resume operation.
Operations are not possible while
this message is displayed.
Contact your service representa-
tive. See "List/Test Print", Gener-
al Settings Guide.
Turn the main power off and back
on. See "Turning On the Power",
About This Machine.
Or, change the settings for [Sys-
tem Settings], [Interface Settings]
and [Network]. See "Network Set-
tings", General Settings Guide.