Configuring The Compact Controller - Samson TROVIS 6493 Mounting And Operating Instructions

Start-up and configuration at the device
7.1.1

Configuring the compact controller

To set a function or parameter, you need to know the abbreviated code used for the function/
parameter and the menu where it can be found (see example in "Configuration and parame-
terization example" on page 7-9, Annex A).
How to proceed:
The controller is in the operating level.
Î Open configuration level.
Reading: PAR (Control parameters menu)
If the function you want to configure is located in a different menu:
Î Select the required menu: IN, SETP, CNTR, OUT, ALRM, AUX, TUNE or I-O
Î Enter menu.
Reading: -CO- and abbreviated code of the first function in the current menu
If you want to configure a different function:
Î Select the function you want to configure.
Î Open function.
Reading: current function setting
Î Activate editing mode for the function.
Current function setting blinks.
Note
Every time you go to the first function or parameter after opening the configuration level,
you are prompted to enter the key number (reading: - - - - and KEY). The key number on-
ly needs to be entered if a key number has already been assigned to the controller (see
the 'Operation' section). If this is not the case, entry of the key number can be skipped by
pressing the enter key (
Î Select the setting.
Î Confirm setting.
Î Change to the parameter level.
Reading: -PA-
7-8
).
EB 6493 EN