Table of Contents
Advertisement
Start-up and configuration with TROVIS-VIEW
Note
An infrared connection must exist during the switchover of the Current set point. Switchover
only functions in offline mode.
Manual/automatic switchover
To change from manual to automatic operation, set Manual/automatic switch to 'Auto' and
transfer the new setting to the controller.
Note
Either transfer the Manual/automatic switch data point or the 'Operation' folder to the con-
troller. The controller does not switch to automatic operation if the entire data record is trans-
ferred to the controller.
Internal error
Î Internal error data point (see the 'Malfunctions' section).
8.2.3
Functions and parameters
The 'Functions and parameters' folder and its subfolders contain all functions of the control-
ler's operating level. The subfolders correspond to the main groups in the controller. Func-
tions and parameters are listed in the folder. Functions are marked with the prefix CO (con-
figuration) and parameters with the prefix PA (parameter). Parameters are listed below the
function to which they belong.
8-6
EB 6493 EN
Hide quick links:
Advertisement
Table of Contents
