Table of Contents
Advertisement
5 Installation
The work described in this section is only to
be performed by personnel appropriately
qualified to carry out such tasks.
5.1 Installation conditions
Work position
The work position for the compact controller
is the front view onto the operating controls
on the compact controller seen from the posi-
tion of operating personnel.
Operators must ensure that, after installation
of the compact controller, the operating per-
sonnel can perform all necessary work safely
and easily access the device from the work
position.
5.2 Preparation for installation
Before installation, make sure the following
conditions are met:
− The compact controller is not damaged.
Proceed as follows:
Î Lay out the necessary material and tools
to have them ready during installation
work.
EB 6493 EN
5.3 Mounting the compact
controller
The TROVIS 6493 Controller is designed for
panel mounting.
Î See Fig. 5-1.
1. Make a panel cut-out with the dimen-
sions 45
x 92
+0.6
2. Place the supplied seal onto the compact
controller. Push the compact controller in-
to the panel cut-out from the front.
3. Insert the supplied mounting clamps (1)
into the top and bottom recesses.
4. Turn threaded rods towards the panel us-
ing a screwdriver, clamping the housing
against the panel.
NOTICE
!
The IP rating will be lower if the controller
is not fastened properly.
Î Tighten the threaded rods far enough to
ensure the specified IP rating is achieved.
Installation
mm.
+0.8
5-1
Hide quick links:
Advertisement
Table of Contents
