Table of Contents
Advertisement
Tech Tip:
If the amp is connected by USB wire and turns off
during the autoremote settings the amp falls in
Update mode. To restart the amp you have to
disconnect the USB and start the amp by cycling
power OFF/ON.
If AC dectection needed don´t forget to do the
jumper settings on PCB.
Autoremote DC detection:
The amp is checking, if there is an at least 3V(DC)
bias voltage provided from the installed source
unit. If so, the amp turns on.
The DC voltage will only be detected on
channels 1+2.
Tech Tip:
The wired remote line is also working in parallel
to the DC detection.
2 Alpine Sound Lab for PDP-E802DSP Status
Here you can find information regarding
software and build versions.
Depending on the environment the
Alpine Sound Lab for PDP‑E802DSP
is used in, you can choose between
a day and a night theme.
Here you can select your preferred
language for the Alpine Sound Lab
for PDP‑E802DSP.
3 Wireless Status and Settings
This section allows to check the configuration of
the wireless adapter WAD‑DPD1.
Basic settings can also be made. Usually the
default configuration will work fine.
25
-EN
Advertisement
Table of Contents
