Alpine PDP-E802DSP Manual page 24

Application Setting Tab
1
2
1 DSP Status
This section shows the serial number of the
amplifier and the firmware version.
1
It is possible to delay switching on
2
and off the amplifier between 1s
and 10s.
The Autoremote feature allows to
switch on the amplifier by detection
of an audio signal. This may help in
cars where no amplifier turn on
signal is available. Options: OFF
(default), AC, DC
Autoremote OFF:
The PDP‑E802DSP will be switched on by
the remote wire.
Autoremote AC detection:
In this mode, the PDP‑E802DSP will detect an
audio signal from a source that is connected to
channels 5+6. Jumpers J2, J3, J5, J6, J38 must be
connected.
24
-EN
3
4
Time ON:
Here you set the duration of the input signal to
be continuously detected above the threshold
limit prior to turning ON.
Threshold ON:
Here you set detection signal level for turning ON.
Time OFF:
Here you set the duration of the input signal to
be continuously detected below the threshold
limit prior to turning OFF.
Threshold OFF:
Here you can set detection signal level for turning
OFF.
Note:
The Threshold ON value should be always be
bigger than Threshold OFF.
3
4