Factory Settings - Alpine PDP-E802DSP Manual

Connect your PC to the PDP-E802DSP:
• Connect your PC with the supplied micro
USB cable.
USB RC WIFI
OPT IN
PROT
STAT
PC
LINK
• If you haven't done so, connect power to
the PDP‑E802DSP. If the amplifier is not
switched on when the PC connection is
established, the PDP‑E802DSP will go to
the 'update mode'.
• Start the software by double clicking the
Alpine Sound Lab for PDP‑E802DSP Icon
on your PC.
• To activate communication to the
PDP‑E802DSP simply press the power icon.
The power icon will also change from
being grey to being blue
Not Connected
Connected
Select „Yes" in the pop‑up window. The DSP amp
is now ready for the system configuration to be
started.
16
-EN

FACTORY SETTINGS

• Input = RCA
• No parallel mode, 8 straight channels
• Input channels 1+2 linked to all output channels
• Analogue input source active
• Remote on by wire
• Highpass for all channels to protect speakers
POWER SUPPLY SPEAKER OUTPUT
All channels are
feed with the
signal from
input 1+2.
USB
OPT IN
PROT
STAT
PC
LINK
INPUT
By default only
channel 1+2 are
active.
RC WIFI