Bridge Function - CDA HNE8FR Installation, Use And Maintenance Manual

will be displayed when the 94°C heating level is active. The cooking
zone indicator will display a
To deactivate the keep warm function
• Touch the relevant zone's keep warm function sensor (12) the
required number of times until the display reads '0' again.
Please note: Any zones that are still hot to the touch will display an
' ' provided the mains power supply is not interrupted.

Bridge function

The hobs are equipped with a bridge function which allows you to
use two heating zones with just one zone's controls. This function is
intended for use with pans such as fish kettles and is available for all
zones. However, only vertically aligned zones can be bridged.
To bridge zones
Touch both heat setting slider sensors (11) of the zones that you want
to bridge. A successful zone bridge will be signified by the bridge
function indicator (4) of both zones illuminating. Only one cooking
zone indicator (2) will be lit however, and it is this zone's controls that
should be used to control the bridge.
To cancel the bridge
Simply touch the same two sliders that were used to activate the
bridge function. If the bridge has been successfully cancelled then
the two zone indicators that were bridged will each display a '0'. The
zones will now be individually operational.
18
.