Using Your Extractor - CDA HNE8FR Installation, Use And Maintenance Manual

Using your extractor

Fig.4
To switch the extractor on and adjust the speed
• To switch the power on, touch and hold the on/off sensor
approximately one second. The extractor should turn on at the
default speed of 2 (represented by 2 solid red bars).
• Use the setting slider to adjust the speed between levels 1 and 4.
To switch the extractor off
• To switch the power off, touch and hold the extractor on/off sensor
for approximately one second.
To set a 10 minute shut off timer
• Touch the timer sensor when any speed is active. This will activate a
10 minute timer, after which the extractor will switch off.
Grease filter saturation
• After approximately 30 hours of total operation, the speed indicators
will all flash simultaneously. This is a sign that the grease filters are
due to be cleaned. Remove the metal grid and the grease filters,
clean the filters using warm, soapy water, dry them and place them
back into the appliance. Press and hold the extractor timer sensor
for approximately 3 seconds when the appliance is on standby to
reset the function.
22
for