Booster Function - CDA HNE8FR Installation, Use And Maintenance Manual

Booster function

The hob is equipped with a booster function on all zones, allowing a
higher power level than the maximum for approximately ten minutes.
To activate the booster on a zone
• Regardless of whether a power level is already set, simply touch
the '+' symbol at the end of the slider for the relevant zone. 'P'
will be displayed on the cooking zone indicator to show that the
booster is on.
• The booster function automatically deactivates after 10 minutes of
usage. The cooking zone will continue to operate at its nominal
power at this point. The booster can be reactivated after this time
provided the hob's internal components have not overheated.
To deactivate the booster on a zone
• To cancel the booster at any time, use the heat setting slider sensor
(11) to return the heat setting to '0' or an alternative level.
Please note: The booster function can not be used on all zones at
once. If two zones in a vertically aligned module are placed on boost,
then the first zone to have been placed on boost will be reduced
to power level 5. Additionally, a bridged pair of zones can not be
boosted. This is to help protect the hob's internal components.
If the appliance's electronic circuits or induction coils overheat
whilst the booster function is in operation then the function will be
automatically deactivated and the zone will continue to operate at its
nominal power. The booster function will be available again once the
internal components have been cooled sufficiently.
11