Using Your Hob(S) - CDA HNE8FR Installation, Use And Maintenance Manual

Using your hob(s)

To switch a hob on
• To switch the power on, touch and hold the on/off sensor (9)
approximately one second. The hob will beep and all cooking zone
indicators will show '0'. The inductor modules will click faintly when
turning the hob on (and off).
Please note: If a power level is not set within ten seconds, the hob
will switch off automatically.
To activate a zone and set a power level
• Simply set the desired power level using the heat setting slider
sensor (11). The standard power levels range from 1 (minimum) to
9 (maximum). The hob will then begin heating providing that the
correct cookware is being used.
To deactivate a zone
• Simply use the heat setting slider sensor (11) to return the heat
setting to '0' for that zone.
• If switching off multiple zones, the above step needs to be taken
for each zone. When all the zones are at '0', the hob will switch off
automatically after approximately ten seconds.
• Alternatively, to switch off the hob immediately, touch and hold the
on/off sensor (9) for approximately two seconds.
Please note: Any zones that are still hot to the touch will display the
symbol ' ' provided the mains power supply is not interrupted.
10
for