Printing Problems - Canon C75, C80, C70 User Manual

Printing Problems

The Alarm light comes on and the unit beeps while printing.
The unit may have a paper jam.
• Clear the paper jam. (
• If the unit has no paper jam, unplug the unit and wait five seconds, then plug it in again. If
the problem is fixed, the Alarm light will turn off, the cartridge holder will move to its home
position on the right side of the unit, and the LCD will return to standby mode. If the Alarm
light remains lit, contact your local authorised Canon dealer or the Canon help line.
Data from the PC is not printed.
The power cord may not be plugged in securely.
• Check that the power cord is plugged securely into the unit and into the wall outlet
( p. 2-9). If the unit is plugged into a power strip, make sure the power strip is plugged in
and turned on.
The printer cable may not be securely connected to the unit and PC.
• Check the printer cable connection. (
The printer cable may not be the correct type.
• Make sure you have the correct printer cable type. (
The unit may have been plugged in or the PC may have been turned on when you
connected the printer cable.
• Unplug the unit and turn off the PC. Plug the unit back in and turn the PC back on again.
• If you are using a USB cable (MultiPASS C75/FAX-B215C only), make sure you connect it
during software installation to ensure proper operation. (
The BJ cartridge or tanks may not be installed properly.
• Make sure the BJ cartridge and tanks are installed properly. (
• Be sure to remove the orange protective tape from the BJ cartridge before you install it.
( p. 2-16)
The BJ cartridge print head may need cleaning.
• Refer to the flow chart (
( p. 12-11)
The BJ cartridge or tanks may need to be replaced.
• Determine if the problem is with the BJ cartridge or tanks (
necessary. ( pp. 12-12, 12-15)
13-22 Troubleshooting
p. 13-4)
p. 2-8)
p. 12-9) and clean the BJ cartridge print head if necessary.
p. 2-8)
Software User's Guide )
pp. 2-13, 12-15)
p. 12-8), and replace if
Chapter 13