Page 16
This is an extension of the Dealer Program Mode. This method of programming is used in conjunction with the Keypad
Programming Worksheets that follow. Refer to these worksheets to identify the 4-digit location (address) of the feature to
be programmed. An illustrative example is provided on the next page.
DATA ENTRY
ADDRESS
LOCATIONS
LOCATIONS
LEFT DIGIT
0000
3
0000
HEXADECIMAL DATA:
TO
BLANK (•) = No Options
1 to 9 = Entries 1 to 9
4093
0 = Entry of 10
B to F = Entries 11 to 15
1. Press
2. Press
3. Press
4. Press
1
GEM-RP1CA/RP1CAe/RP1CAe2 Keypad
1
= ADDRESS LOCATION
GEM-P3200 Programming Instructions
Direct Address Programming allows you to go directly to the address
locations and change the data entries to customize your control panel
RIGHT DIGIT
options. Whereas the Easy Menu Program Mode is a simple quick
C
start guide with limited options, the Direct Address Program Mode is
more flexible allowing you to change all the options.
It consists of multiple address locations (up to 4093) with two data
entry locations each (left and right) as shown in the adjacent diagram.
Master Security Code
(printed on microprocessor can)
Dealer Security Code (Address 0500)
Until "
" (GEM-RP1CAe2) or
"
" (GEM-RP2ASe2) appears on LCD
screen.
To Enter Dealer Program Mode
To Exit Easy Menu Driven Program Mode
& Enter Direct Address Program Mode
2
2
or
GEM-RP2AS/RP2ASe/RP2ASe2 Keypad
= DATA ENTRY LOCATION (Left and Right Digits)
WI818B 5/99
N EXT/YES
PRIOR/NO
AREA
1
2
NAPCO Security Systems
R