Handling An Srx5400, Srx5600, Or Srx5800 Services Gateway Card - Juniper SRX5400 Manual

Handling an SRX5400, SRX5600, or SRX5800 Services Gateway Card

Copyright © 2016, Juniper Networks, Inc.
When carrying a card, you can hold it either vertically or horizontally.
NOTE: A card weighs up to 18.3 lb (8.3 kg). Be prepared to accept the full
weight of the card as you lift it.
To hold a card vertically:
Orient the card so that the faceplate faces you. To verify orientation, confirm that the
1.
text on the card is right-side up and the EMI strip is on the right-hand side.
Place one hand around the card faceplate about a quarter of the way down from the
2.
top edge. To avoid deforming the EMI shielding strip, do not press hard on it.
Place your other hand at the bottom edge of the card.
3.
If the card is horizontal before you grasp it, place your left hand around the faceplate and
your right hand along the bottom edge.
To hold a card horizontally:
Orient the card so that the faceplate faces you.
1.
Grasp the top edge with your left hand and the bottom edge with your right hand.
2.
You can rest the faceplate of the card against your body as you carry it.
As you carry the card, do not bump it against anything. Card components are fragile.
Never hold or grasp the card anywhere except those places that this topic indicates are
appropriate. In particular, never grasp the connector edge, especially at the power
connector in the corner where the connector and bottom edges meet (see
Figure 39 on page 56).
Handling an SRX5400, SRX5600, or SRX5800 Services Gateway Card
55