Reassemble Nozzle; Final Status - Cornelius ABS 2.0 Operator's Manual

ABS 2.0 Operator's Manual
R N
EASSEMBLE OZZLE
Step
Reinstall the diffuser gasket in the diffuser by
aligning the square notch on the gasket and the
diffuser as shown in Figure 50.
1.
NOTE: Ensure gasket is seated properly and
correct side is facing upwards.
Reinstall the diffuser by pushing it upward and
2. aligning the diffuser tabs in place as shown in
Figure 51.
Reinstall the outer housing in the unit by rotating
it in the clockwise direction as shown in Figure
52.
3.
NOTE: Tabs must be aligned & apply
upward force while twisting to avoid
cross threading. Check if the nozzle
is level after install.
F S
INAL TATUS
Step
Great job cleaning your ABS 2.0! This will keep
your ABS 2.0 running great!
1.
Daily cleaning complete.
Publication Number: 621058590OPR
Table 19. Reassemble Nozzle
Action
Table 20.
Action
Figure
Figure 50.
Figure 51.
Figure 52.
Figure
Figure 53.
- 30 - © 2019, Cornelius Inc.