Normal Operations; Location, Power On Unit & Usage; Location Of Unit; Power On Unit - Cornelius ABS 2.0 Operator's Manual

Hide thumbs Also See for ABS 2.0:

Service manual (68 pages)

Installation manual (66 pages)

Operator's manual (58 pages)

Table Of Contents

Table of Contents

, P

OCATION

OWER

Location Of Unit

Locate the dispenser so that the following requirements are satisfied:

1. Unit is not to be installed in an area where a water jet (power washer) is used.

2. Unit must be located in an area with a level floor surface. The unit must be installed within 2° of level for

the unit to operate properly.

3. The unit should only be installed in a location where its use and maintenance is restricted to trained per-

sonnel.

4. Unit must be located in an area with nearest access to floor drain port, preferably under the foot print of

unit.

5. The clearance above top of the unit must be open and the front of the unit must be open to the room.

These clearances must be provided to allow for proper air flow and to allow access to the ice bin for refill-

ing.

Power On Unit

DANGER:

o avoid possible fatal electrical shock or serious injury to the operator, it is highly recommended that a

(ground fault circuit interrupter) be installed in the electrical power circuit.

The machine is equipped with a power cord (hot, neutral and ground) and is plugged into any standard wall

outlet capable of handling as shown in Table 3 on page 7.

Unit

Plug Type

ABS 2.0

IEC-NEMA 5-15P

ABS 2.0

CEE7/7

ABS 2.0

BS1363A

ABS 2.0

AS3112

CAUTION:

he electrical circuits must be properly fused (Slow-blow type fuses).

breakers on the circuit of the unit.

damage the electronics

NOTE: The electrical outlets must be accessible for ease of connecting and disconnecting the

dispenser cords. No other electrical appliances should be connected to these electrical

circuits.

NOTE: All electrical wiring must conform to national and local electrical codes.