Appendix B - Adm Setup Screens Overview - Graco VRM 24F872 Instructions Manual

Appendix B - ADM Setup Screens Overview

Setup Screens Navigation Diagram
Shot #1 Sequences #1
Shot #2 Sequences #2
Shot #... Sequences #...
Shots
This screen allows the user to edit shot definitions. The
contents of this screen change based on the Dispense
Mode. Shots may be defined by flow rate and by
time (duration), volume, or weight depending on the Dis-
pense Mode selection. See System #1 on page 61 for
Dispense Mode options.
Using the button
The button can be used to change multiple shot
definitions at once.
1. From the Shots screen, press
2. Press .
3. Navigate to a shot definition value.
313873J
Calibration
System #1
System #2
System #3
.
Appendix B - ADM Setup Screens Overview
Maintenance Supply
4. Type the new value then press enter. All values
below the selected shot will change to the new
value.
5. Repeat the previous two steps as desired.
6. Press to deactivate.
Using the button
The button can be used to calculate an x:1 ratio
from a non x:1 ratio. For example, if the desired ratio is
5:2, the button can be used to convert 5:2 to 2.5:1.
1. From the Shots screen, press
2. Navigate to the
3. Press .
4. Enter the non x:1 ratio in the
culated x:1 ratio will automatically be displayed in
the column and in the shot definition.
5. Press .
Conditioning #1 Advanced #1
Conditioning #2 Advanced #2
Conditioning #3 Advanced #...
.
column.
column. The cal-
59