Models - Graco VRM 24F872 Instructions Manual

Models

Models
System approved
24F872
24F391

24F873
* Full load amps with all devices operating at maximum capabilities. Fuse requirements at various flow rates and
mix chamber sizes may be less.
** Values are dependent on installed pump size. Values shown are for largest available pump size.
 Flow rate is independent of frequency 50/60 Hz.
‡ If a motor control module is replaced, see the Adjust Motor Control Module Selector Switch section in the
VRM repair manual to set the machine to the proper maximum fluid working pressure.
4
Full Load
Peak
Amps Per Voltage System
Phase* (phase) Watts†
60 A 230 (3)
55 A 400 (3) 24,000
55 A 400 (3)
Approximate
Max Flow Output per
Rate** Cycle (A+B)**
lb/min (kg/min) gal. (liter)
66 (30) 1.0 (3.8)
Hydraulic Maximum Fluid
Pressure Working Pressure ‡
Ratio** psi (MPa, bar)
1.63 2000 (14, 138)
313873J