Graco VRM 24F872 Instructions Manual page 27

Navigation Overview
For all ADM screens to be accessible and functional, the
ADM must be enabled and an operating mode other
than Standby or Disabled must be selected.
NOTE: The optional Diagnostic screen can be enabled
from Advanced #3 screen, see page 64.
To navigate between screens use the arrow keys on the
ADM keypad. To access the Setup screens,
press . If the Setup screens password is turned
on, use the ADM keypad to enter the password then
press . For Setup screens information, see Appen-
dix B - ADM Setup Screens Overview on page 59. For
Run screens information, see Appendix C - ADM Run
Screens Overview on page 65.
If a screen has been entered by pressing
system is in editing mode then navigating to a different
screen will be disabled. As applicable, exit the screen
and editing mode to re-enable screen navigation.
313873J
Change ADM Values
To edit information in a screen, such as a shot definition
or a system setting like time or date format, follow this
general process:
1. Press
NOTE: Operator mode flow settings are edited using a
slightly different process. To edit dispensing settings
when in Operator mode, see Dispense in Operator
Mode section on page 39.
2. Once in the screen, use the arrow keys to navigate
to the desired item.
3. Edit the value:
• If the item has a drop-down list to select
from, press
Use the up and down arrow keys to highlight the
desired item then press
• If the item is a numeric value, use the numeric
keypad on the ADM to type the new value then
press
• If the item is a select/deselect or enable/dis-
able checkbox option, press
the value.
• If necessary, press
4. Press
or if the
.
to display the dropdown list.
to select the item.
to accept the value.
to cancel editing.
.
Operation
to toggle
27