Transfer System Settings - Graco VRM 24F872 Instructions Manual

Transfer System Settings

Use the following process to transfer system settings
from one machine to another.
1. Insert a high-quality USB stick-drive into the ADM
USB port on the system with the settings to be
transferred. Once the download is complete the
SETTINGS.TXT file will be located in the "DOWN-
LOAD" folder.
NOTICE
The user should never attempt to modify the SET-
TINGS.TXT file in any way. Graco is not responsi-
ble for damages caused by an improperly modified
setup file.
2. Plug the USB stick-drive into a computer.
3. Navigate to the DOWNLOAD folder.
4. Copy the SETTINGS.TXT file from the DOWNLOAD
folder into the UPLOAD folder.
5. Remove the USB stick-drive from the computer and
install it into the ADM USB port for the second
machine. The software will automatically begin
updating.
313873J
NOTE: Before the update begins the ADM automatically
shuts down the system, aborting any in-progress dis-
pensing. When the software is updating a pop-up box
will appear to inform the user of the update and the sys-
tem will lock. Once the update is complete the ADM will
tell the user to cycle power to apply the updates.
6. When the software is done updating, remove the
USB stick-drive.
7. Turn the Main Power Switch to the OFF position
then back to the ON position.
8. Plug the USB stick-drive into a computer.
9. Navigate to the UPLOAD folder and remove the
SETTINGS.TXT file.
NOTE: Immediately after uploading the settings,
remove the SETTINGS.TXT file from the UPLOAD
folder to prevent accidental loss of data the next time
the USB stick-drive is inserted into the ADM USB port. If
there is a SETTINGS.TXT file in the UPLOAD folder
when the USB stick-drive is inserted into the ADM USB
port the software will automatically begin updating.
Appendix E - USB Operation
83