Adjusting The Motion-Control Linkage - Toro Spray Master Operator's Manual

4. Tighten the 2 knobs that secure the speed bar
(Figure 95).
Adjusting the
Motion-Control Linkage
1. Prepare the machine for maintenance; refer to
Preparing the Machine (page
2. Loosen the 2 knobs that secure the speed bar,
and push the speed bar forward
1. Knobs
3. Push the motion-control lever forward, and
measure the distance between the speed bar
and motion control lever
Note:
The motion-control linkage is correctly
adjusted when the gap between the lever and
bar is 79 to 87 mm (3-1/8 to 3-7/16 inches).
49).
(Figure
Figure 96
2. Speed bar
(Figure 97).
96).
1. 79 to 87 mm (3-1/8 to
3-7/16 inches)
2. Less than 79 mm (3-1/8
inches)
4. If the gap is larger than or smaller than 79 to 87
mm (3-1/8 to 3-7/16 inches), remove the knee
g313360
pad; refer to
5. Loosen the 2 jam nuts that secure the
motion-control rod at the upper and lower ball
joints
67
Figure 97
3. More than 87 mm (3-7/16
inches)
Removing the Knee Pad (page
(Figure 98).
g313359
49).