Cleaning The Sprayer - Toro Spray Master Operator's Manual

Lubricating the Spreader
1. Apply water-displacing lubricant to the control
cables and pivot points as shown in
Figure 49
2. Allow the spreader-sprayer to completely dry
before the next use.

Cleaning the Sprayer

Service Interval: After each use
WARNING
Swallowing or inhaling chemicals could cause
serious injury or death.
• Do not clean sprayer nozzles using your
mouth or blowing through the nozzles.
• Replace all worn and damaged sprayer
nozzles.
• Ensure that the nozzles are installed
correctly.
Important:
Do not use brackish or reclaimed
water to clean the machine.
Preparing the Machine
1. Empty the sprayer tank.
2. Fill the sprayer tank with 19 L (5 US gallons) or
more of clean water and install the cap; refer to
Filling the Tank (page
Figure 49.
3. Engage the parking brake, move the
motion-control levers to the N
and start the engine.
4. Set the engine throttle to F
Cleaning the Sprayer System and
Wand
Important:
immediately after each use. Failure to do so
may cause the chemicals to dry or thicken in the
hoses, clogging the pump and other components.
1. Adjust the sprayer-pressure with the throttle
valve; refer to
(page
2. Set the left, center, and right boom
sprayer-control valves to the O
3. On the control console, press the spray-pump
switch to turn on the spray pump; refer to
Spray-Pump Switch (page
4. Allow the rinse water in the tank to spray through
the nozzles.
5. Check that all nozzles spray correctly.
g312832
6. Remove the sprayer wand from the holder, point
the wand in a safe direction, and squeeze the
trigger; refer to
(page
Note:
the wand for 1 to 2 minutes.
7. Release the trigger for the wand and return it to
the tool clip on the machine; refer to
with the Spray Wand (page
8. Move the boom sprayer-control valves to the
O
O
9. Clean the strainer; refer to
(page
10. Repeat steps
neutralizers recommended by the chemical
manufacturers; refer to
38).
11. Repeat steps
42
38).
Always empty and clean the sprayer
Adjusting the Sprayer Pressure
36).
Spraying with the Spray Wand
39).
Allow the rinse water to discharge from
position, set the sprayer-pump switch to the
FF
position, and shut off the engine.
FF
43).
2 through
Filling the Tank (page
2 through 9
position,
EUTRAL
position.
AST
position.
N
15).
Spraying
39).
Cleaning the Strainer
9 using cleaners and
using clean water only.