Checking The Engine-Oil Level - Toro Spray Master Operator's Manual

Checking the Engine-Oil
Level
Service Interval: Before each use or daily
Important:
Do not operate the engine with the oil
level below the Low (or Add) mark on the dipstick,
or over the Full mark.
1. Move the machine to a level surface.
2. Prepare the machine for maintenance; refer to
Preparing the Machine (page
3. Rotate open the right spray tank and allow the
engine to cool; Opening the Tanks (page
4. Remove the dipstick from the engine and wipe
the dipstick with a clean rag
Figure 70
1. Dipstick and filler neck
5. Insert the dipstick into the engine , and tighten
the dipstick Figure
49).
50).
(Figure 70).
71.
1. Maximum oil level
(dipstick)
2. Minimum oil level (dipstick)
6. Remove the dipstick from the filer neck, and
check oil level on the dipstick
Note:
The engine oil level must cover the
hatch-marked area of the dipstick
7. If the oil level is low, wipe off the area around the
filler neck and add the specified oil
until the oil level is between the hatch marked
areas on the dipstick.
g312874
Important:
oil.
8. Hand tighten the dipstick into the filler neck
(Figure 70).
9. Close and secure the right spray tank; refer to
Closing the Tanks (page
54
Figure 71
3. Filler neck
(Figure
(Figure
(Figure
Do not overfill the engine with
Figure 72
51).
g312872
71).
71).
72)
g312937