Adjusting The Motion Control Tracking - Toro Spray Master Operator's Manual

Figure 98
1. Left motion-control rod
2. Right motion-control rod
3. Ball joint
6. Adjust the motion-control rod as follows:
•
To increase the gap between the speed
bar and motion control lever, rotate the
motion-control rod counterclockwise.
•
To decrease the gap between the speed
bar and motion control lever, rotate the
motion-control rod clockwise.
7. Tighten the jam nuts
8. Repeat steps 3 through
control lever.
9. Install the knee pad; refer to
Pad (page 50).
Adjusting the Motion
Control Tracking
If the machine travels or pulls to one side when the
motion-control levers are in the full forward position,
adjust the tracking.
1. While driving the machine across a flat field,
push both control levers forward the same
distance.
2. Check if the machine pulls to one side, stop the
machine, shut off the engine, and engage the
parking brake.
4. Jam nut
5. Jam nut (rod adjustment)
(Figure 98).
7 for the other motion
Installing the Knee
3. Loosen the 2 jam nuts that secure the
motion-control rod at the upper and lower ball
joints (Figure
g313362
1. Left motion-control rod
2. Right motion-control rod
3. Ball joint
4. Adjust the motion-control rod as follows:
•
To increase the speed for the drive, rotate
the motion-control rod counterclockwise in
1/4 turn.
•
To decrease the speed for the drive, rotate
the motion-control rod clockwise in 1/4 turn.
5. Tighten the jam nuts
6. Repeat steps
tracks straight when the motion-control levers
are in the full forward position.
68
99).
Figure 99
4. Jam nut
5. Jam nut (rod adjustment)
(Figure 99).
1 through 5 until the machine
g313362