Servicing The Spark Plug - Toro Spray Master Operator's Manual

Figure 76
1. Dipstick and filler neck
2. Slowly pour 1.6 L (56 fl oz) of the specified oil
into the filler neck
refer to Engine Oil Specification (page
Figure 77
3. Insert the dipstick into the filler neck and tighten
the dipstick Figure
4. Remove the dipstick from the filler neck and look
at the oil level in the dipstick
Note:
The engine oil level must cover the
hatch-marked area of the dipstick
(Figure 77) of the engine;
53).
76.
(Figure 78).
(Figure
g312874
1. Maximum oil level
(dipstick)
2. Minimum oil level (dipstick)
5. If the oil level is low, add the specified oil into the
engine until the oil level is between the hatch
marked areas on the dipstick
Important:
oil.
6. Insert the dipstick into the filler neck and hand
tighten the dipstick
7. Close and secure the left and right spray tanks;
refer to
g312937

Servicing the Spark Plug

Service Interval: Every 100 hours
Spark Plug Specification
Spark plug type: Champion
78).
Removing the Spark Plug
1. Prepare the machine for maintenance; refer to
Preparing the Machine (page
2. Rotate open the left and right spray tanks; refer
to Opening the Tanks (page
3. Remove the spark plug as shown in
56
Figure 78
3. Filler neck
(Figure
Do not overfill the engine with
(Figure 78).
Closing the Tanks (page
® RJ12
50).
g312872
78).
51).
49).
Figure 79.