Serial Remote Control Terminal - Denon DN-V310 Instructions Manual

1

Serial Remote Control Terminal

Remote control of the DN-V310 is possible by connecting the serial interface of a PC, etc., to the serial
remote terminal on the rear panel. The commands usable with serial remote are categorized in three
groups, the PC group controlling the DN-V310, the PS group for acquiring information on the
DN-V310's operating status, and the PR group of status information issued asynchronously from the
DN-V310 in response to changes in operating status. The details of the commands are described each
group. The DN-V310's serial remote terminal is compatible with RS-232C standards.
Standards
Connector type
Synchronization Asynchronous
Baud rate
Data length
Parity
Stop bit
Flow control
Use a male/female serial straight cable to connect to a personal computer.
To prevent damage to the DN-V310 and the controller, turn off the power of both the
DN-V310 and the controller when connecting the serial cable.
Also be sure the settings of the control side's communications specifications (data length,
baud rate, stop bit, flow and parity) match those of the DN-V310 (shown on the table above
at the left).
The DN-V310 cannot be used with CTS and RTS signals. If such signals are being received
and controlled on the controller, take the proper measures for the controller's software
and/or hardware.
Conforming to RS-232C
D-sub female 9-pin
9,600 bps
8 bits
None
1 bit
None
Pin
No.
1
2
3
4
5
6
7
8
9
DN-V310 side
Signal name
No connection
ＴＸＤ
ＲＸＤ
No connection
ＧＮＤ
No connection
CTS
RTS
No connection
NOTES
４
5
9
[ D-sub 9pin female connector ]
DN-V3１0 side
Input/Output
（DN-V310）
-
Output
Input
-
-
-
Input
Output
-
1
6